April 23, Nanchang, Jiangxi Province, 350-401 test passed

The lab questions are still the same 6 questions. Don’t panic if the ping doesn’t work for the vrf question. I did it twice and it still didn’t work, but the result was correct. What I remember most clearly is that the span question monitor session 12 source interface VLAN 10’s VLAN 10 is always invalid input, and there is a small sharp corner below, so you can only change it to e0/0 (corresponding to vlan10). The name of the Netflow monitor is Monitor-NetflowR1. For the port-channel question, after entering int range e0/0-2, remember to first no switchport mode access. Check the loopback 0 address show ip int lo 0, and so on.
There are 4 multiple-choice questions that I haven’t seen before, so it doesn’t have much impact. Wish you all good luck