Feedback

There were four lab questions, one of which was a modified DMVPN question, but I didn't complete the requirements. The other three were about syslog, acl-1, and mgre, all covered by the question bank. There were no new questions for the drag-and-drop diagram or multiple-choice questions ... Read More…

There are 110 questions in total, including 12 new multiple-choice questions and 5 new image-based questions. I remember the following: 3 of the multiple-choice questions are about AI/ML, and 2 of the image-based questions are about the relationship between various SDN functions ... Read More…

There are 6 lab questions, 52 multiple-choice questions, and 4 questions with diagrams. All 6 lab questions are included in the question bank, covering CoPP, NetFlow/SPAN/SLA, VRF, eBGP, pot channel, and OSPF. Some parameters have been modified. Please pay attention to the question and modify them accordingly (mask interface, port-channel ID, OSPF aggregation mask). There are approximately 12 new multiple-choice questions, and all the diagram questions are included in the question bank. You can only proceed to the subsequent multiple-choice diagram questions after completing the 6 lab questions. You submit each question individually; you cannot go back and review the previous content. Finally, PASS! ... Read More…

I passed the exam. I took it in Fuzhou. Experimental questions: CoPP, NetFlow/SPAN/SLA, VRF, eBGP, pot channel, OSPF The lab questions were the same, but with some changes. The COPP section was task 2 permit ssh and then OSPF summary. There were a few multiple-choice questions, but I don't remember much ... Read More…

50 questions in total, 4 LAB questions, and 1 drag-and-drop question. LAB includes DMVPN, SYSLOG-1, and two new lab questions. 1. New lab question 1 deals with AAA authentication. The console requires no password, and only vty connections and enable are allowed. Username: cisco Password: cisco Privilege: 15 Add to the aaa authentication telnet section: 9 G; b- M2 g1 f E. J) z The ACL for BR1 and BR2 has a default deny network segment. Add a new permit segment to allow ISP BGP connections. 2. New lab question 2 deals with BGP connections. Some routers must only permit certain AS-paths and deny others. This requires using an ip as-path access-list and applying it to an existing route-map. I'm just unlucky to have encountered a new LAB, but the drag-and-drop questions and multiple-choice questions are almost identical to the question bank ... Read More…

I just passed the CCNP ENCOR exam. I'm hoping to finish the remaining one within three years, as it's not currently required for my current job, so I'm planning to take it when it expires. Experience: CoPP, NetFlow/SPAN/SLA, VRF, eBGP, pot channel, OSPF. There are 60 questions in total. The lab questions are the same, no new ones. The only change is the Exporter name in the NetFlow question. There are new multiple-choice questions, two of which seem to be from sections 300-410. One of the multiple-choice questions asks about Http2, and the answer is (single/multiple requests are transmitted using single/multiple channels). The multiple-choice questions also have a question about TLOC, if I remember correctly. There are four diagram-dragging questions, no new ones, all the same ... Read More…

Passing the 00-410 exam consists of 50 questions, including 4 lab questions, 45 multiple-choice questions, and 1 diagram-based question. The multiple-choice questions are relatively new, but they are not difficult to answer with a calm mind. There should be no new diagram-based questions. The 4 lab questions are: redistribution DMVPN Syslog BGP (modified question) ... Read More…

This exam consists of 50 questions, including 4 practical questions and 46 multiple-choice and diagram questions. The practical questions cover redistribute, syslog-1, mGRE-1, and one VRF question not included in the question bank. 1. The requirements for the practical questions often differ from those in the question bank. For example, the mGRE question only requires adding a password, but the default configuration contains some errors. You need to first remove the incorrect settings with "no" and then add the correct configuration. Memorizing the answer from the question bank can get you stuck, so it's best to understand the requirements and logic in the question bank so you can adapt in the exam. Regarding the VRF question, the loopback IPs of the Finance and Admin VRFs must be interoperable, but I only completed half of the requirements. 2. I encountered one new question in the diagram question, and about seven or eight multiple-choice questions were not in the question bank. However, as long as you understand the requirements, you should be able to determine the correct answer. 3. In summary, it's still important to be familiar with the question bank, which includes practical, multiple-choice, and diagram-based questions. However, practical questions will likely not be exactly as per the question bank. Cisco often changes requirements or introduces incorrect settings, so you need to be able to troubleshoot and make corrections. Memorizing commands will help you make quick decisions, while understanding the protocol and the programming language will require you to rely on your own understanding and experience to solve the complex problems ... Read More…

I passed. Thanks for the help. The exam was held in Hsinchu, Taiwan. There were 60 questions, 6 lab questions, and I remember 5 questions being dragged. The lab questions covered CoPP, NetFlow/SPAN/SLA, VRF, eBGP, pot channels, and OSPF. There was one new lab question about a flow exporter using UDP port 2055 for transmission, which wasn't in the question bank. There was also one JSON question in the dragged section, which I hadn't seen before. There were about 3-4 multiple-choice questions that I hadn't seen before ... Read More…

On June 17th, the CCDE written exam 400-007 at the Nanning test center was passed. As a person from Guangxi, I think this exam was quite easy. Although I only had 3 weeks for review, I kept practicing the question bank every day, and the effect was very obvious. Finally, I got 850 points and was very satisfied! I encountered about 13 - 4 new questions in the exam, and the rest were original questions from the question bank. The question bank was really helpful ... Read More…